40
Appendix
Replacing a handset
NOT REGISTERED
It may be necessary to de-register your handsets if:
You have the maximum number of registered handsets (four) and need to
replace a handset.
-OR-
You wish to change the designated handset number of your registered hand-
sets.
You must first de-register ALL the handsets, and then re-register ALL the
handsets you wish to use.
Please read carefully through all the instructions on this page before begin-
ning the de-registration process.
To de-register all handsets
1. Press and hold
HANDSET LOCATOR
on the telephone base for about 10
seconds (until the
IN USE
light turns on and starts to flash), then release
the
HANDSET LOCATOR
button.
2. Immediately press and release
HANDSET LOCATOR
again. You must
press
HANDSET LOCATOR
while the
IN USE
light is still flashing. (The
light flashes for about seven seconds. When the light stops flashing, pick
up the handset and place it back into the telephone base, then start again
with step number one above).
3. The handset(s) will show
CONNECTING...
and it will take about 10 seconds
to complete the de-registration. ALL handsets will show
NOT REGISTERED
if de-registration is successful.
4. To re-register the handset(s) to the telephone base, follow the registration
instructions on page 39.
NOTES:
1. If the de-registration process is not successful, it may be necessary to reset the system
and try again. To reset: pick up the handset and press
PHONE/
FLASH
, then press
OFF/
CLEAR
and place the handset back into the telephone base. You may also reset by
unplugging the power from the telephone base and plugging it back in.
2. You cannot de-register the handset(s) if any telephone connected to the same telephone line
is in use.
