AT&T DMOH
Connecting a Power Supply
Connect the output plug from the power supply to the 12V AC/DC jack on the rear
panel of the unit. Plug the power supply into any convenient 110V AC outlet.
Connecting to the Telephone System
Use the audio patch cord terminated with an RCA plug (included) to connect the LINE
600 ohm or 1 WATT output to the telephone system's music-on-hold (MOH) input.
Refer to page 9 for wiring connections. All MOH connections should be per the
specific telephone system (Merlin, Partner, etc.) requirements.
Connecting an External Speaker
The 1 WATT output RCA jack can be used to power an external speaker. The output
provides 1 watt into 8 ohms. The LINE 600 or 1 WATT outputs can also be used to
feed the input of a loudspeaker system's amplifier.
Loading Cassette Tape
Use the following procedure to load a Magic On Hold cassette tape.
·
Set the sampling rate/memory capacity using the MODE switch on the underside
of the unit.
·
Place the POWER switch in the ON position. The red POWER indicator will
illuminate.
·
Be sure the SPEAKER switch is in the on position (if desired), and set the VOLUME
control between its minimum and maximum positions
·
Open the tape compartment door and insert the cassette tape. The tape direction
is indicated on the compartment door. Close the tape compartment door.
The unit rewinds the cassette tape (if necessary) and then begins to play. It plays
(preview) approximately 5 seconds of the audio message and then stops (the
RECORD and PLAY indicators do not illuminate during the preview). The tape heads
then retract for approximately 5 seconds following the preview, allowing you to
remove the cassette, if desired. If you do not remove the cassette, it rewinds and the
message downloads into digital memory (the RECORD indicator illuminates when
downloading starts). Adjust the volume for comfortable listening level during
downloading and play.
