Using the AT&T Digital Announcer
Recording an Announcement
With the Digital Announcer, you can record announcements from
either the handset provided with the unit or a cassette tape player.
Recording with the Handset
NOTE:
If this unit is being used in a contact activated start
application, disconnect its cord from the Line connector on
the rear panel before recording the announcement.
To record an announcement with the handset, perform the
following steps:
1.
Plug the handset cord into the Handset jack on the rear
panel of the unit.
2.
Press the Select button on the front panel of the unit to
select the Message LED (M1 or M2) of the announcement
you want to record.
Depending on the announcement you selected, either the
M1 or M2 LED turns on. If no announcement has been
recorded yet for the Message LED you selected, the
Message LED blinks slowly.
3.
Press and hold the Mode button until the Message LED you
selected (M1 or M2) starts blinking rapidly.
3-2
