Telephone base installation
This quick start guide provides you with basic instructions only.
For more complete instructions, refer to your Abridged user’s
manual provided in the package, or see the online Complete
user’s manual at www.telephones.att.com/manuals.
Battery installation
Install the battery, as shown below. Charge your handset(s) before initial use.
The battery is fully charged after ten hours of continuous charging.
Quick start guide
CL82114/CL82214/CL82314/CL82364/CL82414/
CL82464/CL82514
Caution:
Use only the power adapter(s) provided with this product. To obtain a replacement,
visit our website at
www.telephones.att.com
or call
1 (800) 222-3111
.
In Canada, dial
1 (866) 288-4268
.
Quick reference guide - handset
Step 1
Plug the battery connector securely into the socket inside the handset battery
compartment. Insert the supplied battery with the label
THIS SIDE UP
facing up,
as indicated.
Step 2
Align the cover flat against the battery compartment, then slide it upwards until
it clicks into place.
Step 3
Charge the handset by placing it face forward in
the telephone base or charger. The
CHARGE
light
on the handset is on during charging.
PUSH TO TALK
Press to initiate a one-to-one or
one-to-group broadcast.
Press and hold to broadcast to a group of
system handsets.
•
•
Quick reference guide - telephone base
CHARGE light
On when the handset is
charging in the telephone base
or charger.
REDIAL/PAUSE
Press repeatedly to view the
last ten numbers dialed.
While entering numbers,
press and hold to insert a
dialing pause.
•
•
q
CID/VOLUME
Press
q
CID
to show caller
ID log when the handset is
not in use.
Press to scroll down while
in menus.
Press to decrease the
listening volume when on
a call.
•
•
•
PHONE/FLASH
Press to make or answer
a call.
1
Press and hold to set or dial
your voicemail number.
TONE /a>A
Press to switch to tone
dialing temporarily
during a call if you have
pulse service.
While entering names, press
to change the next letter to
upper or lower case.
•
•
/SPEAKER
SPEAKER
Press to make or answer a call
using the speakerphone.
p
DIR/VOLUME
Press
p
DIR
to show
directory entries when the
handset is not in use.
Press to scroll up while
in menus.
Press to increase the
listening volume when on
a call.
•
•
•
MENU/SELECT
When the handset is not
in use, press to show
the menu.
While in the menu, press to
select an item or save an
entry or setting.
•
•
OFF/CANCEL
During a call, press to
hang up.
While in a menu, press to
cancel an operation, back
up to the previous menu,
or exit the menu display; or
press and hold this button
to exit to idle mode.
•
•
QUIET# (pound key)
Press and hold to enter the
QUIET
mode setting screen, or
to deactivate
QUIET
mode.
MUTE/DELETE
During a call, press to mute
the microphone.
Press to delete digit
or character.
•
•
EQ
During an outside call,
intercom call, message or
announcement playback, press
to change the audio quality to
best suit your hearing.
Charger installation
Plug the power adapter
into a power outlet not
controlled by a wall
switch.
Handset
side view
Raise the antenna.
Route the power
adapter cord
through this slot.
Plug the large end
of the telephone
base power
adapter into a
power outlet not
controlled by a
wall switch.
Plug one end of
the telephone
line cord into a
telephone jack
or a DSL filter.
If you have DSL
high-speed Internet
service, a DSL filter
(not included) is
required.
Plug the other end
of the telephone
line cord into the
telephone jack on
the back of the
telephone base.
Plug the small end of the
telephone base power
adapter into the power
adapter jack on the back of
the telephone base.
Route the
telephone line cord
through this slot.
CHARGE
light
Use only the supplied rechargeable battery or replacement battery (model
BT183342/
BT283342).
/
REPEAT
Press to repeat a message.
Press twice to play the
previous message.
•
•
Message counter
Shows the number of messages or other answering system
information.
/HANDSET LOCATOR
While the phone is idle,
press to page all handsets.
IN USE indicator
On when the handset is in use,
or when the answering system
is answering an incoming call.
Flashes when another
telephone is in use on the
same line.
•
•
X/DELETE
Press to delete the message
currently playing.
Press twice to delete all old
messages when the phone is
not in use.
•
•
q
VOLUME and
p
VOLUME
During message playback,
press to adjust the listening
volume.
While in idle mode, press to
adjust the base ringer volume.
•
•
/PLAY/STOP
Press to start or stop message
playback.
/
SKIP
Press to skip a message.
Initial settings
We recommend you program your telephone system before use.
The following are a few examples of common features to set before using the
telephone. Refer to the
Handset settings
and
Answering system settings
in
the Abridged user’s manual or the online Complete user’s manual for detailed
instructions on setting all telephone features.
Set date/time
Set the date/time before using the answering system.
MENU
->
q
or
p
->
Set date/time
->
SELECT
.
Enter the month, day and year using the dialing keys
->
SELECT
.
Enter the hour and minute using the dialing keys.
q
or
p
to choose
AM
or
PM
->
SELECT
.
1.
2.
3.
4.
Basic answering system setup via voice guide
Your can follow the voice guide to record your own announcement, set the
number of rings, and set the message alert tone.
Using a cordless handset:
MENU
->
q
or
p
->
Answering sys
->
SELECT
.
q
or
p
->
Voice guide
->
SELECT
.
Set up your answering system by inputting the designated numbers,
as instructed.
1.
2.
3.
/ANS ON/OFF
Press to turn the built-in
answering system on or off.
T
Battery Pa
BT162342/B
WA
RNING /
AV
DO NOT BURN
O
NE P
AS INCINÉRER
Made in China / Fabr
i
THIS
SIDE
UP / CE
CÔ
TÉ
VERS LE HA
UT
Batte
ry Pa
ck / Bloc
-piles
:
BT
183342/BT2833
42 (2.4V
400
mAh Ni-MH)
WARNI
NG
/ A
VERTISSEMENT
:
DO NOT BURN OR PUNCTURE BA
TTERIES.
NE
PA
S INCINÉRER OU PERCER LES PILES
.
Made in China / Fabriqué
en chine
CR134
9
AU
T
MH
)
423
