TABLE
J
ALL 832/2832-TYPE TE LEPHONE
SET CONNECTIONS TO DISABLE
PRIVACY R E LEASE BUTTON
MOVE LEAD I N TE L SET
COLOR
FROM TERM.
TO TERM.
0-BK
15
TABLE K
832A AND 2832A TE LEPHONE SET CONNECTIONS
FOR R ECALL BUTTON (D-180591 KI T O F PARTS)
651F KEY
CONNECT TO
LEAD COLOR
TERMINAL BOARD
NETWORK
w
w
R
y
4
y
6
Note:
Remove
Y
strap from
4
and
6
on
telephone set terminal board.
M. Station Busy Consoles (Fig.
48
and
49)
4.83
If only one console is to be used with a 7 A
System, cut down its A25B connector cable
on column E (DSS console) or column D (MW
console) of block 3 in the KSU (Fig. 50 and 51).
However, if more than one console is to be installed,
auxiliary connection blocks may be required and
additional power connections must be made. Fig. 52
through 58 provide connecting information for all
permissible multiconsole installations.
Refer to
Table N for an index to these diagrams.
If one or more DSS consoles are to
be installed, be sure that the DO to
Dl and CGO to CGl straps on connecting
block 3 are removed (see connection
diagrams).
If no DSS console is
installed, be sure tha t the straps
are in place.
ISS 3, SECTION
5 1 8-450- 1 00
Station Busy Console
(
6A 1 )
With DSS
4.84
By depressing the appropriate button on
the 6Al console, an attendant may signal
any station over the intercom or make announcements
over the paging system. The console also provides
the attendant with a visual indication of a busy
station. Seventeen buttons on the console correspond
to the station codes (codes 3 through 19); one
button is associated with paging, one button is
arranged for recall, and one button is spare. See
Fig. 48 for schematic of 6Al selector console.
4.85
Any station having the handset off-hook
lights a lamp under the associated button
on the 6Al/DSS console as a visual indication of a
busy station. The operated switchhook contacts
of a telephone set extend ground over an SB( )
lead, through the KSU to the 6Al console, thus
lighting the lamp under the associated button in
the DSS field.
4.86
To DSS from the 6Al console:
(1) Lift handset on the associated telephone
set.
(2) Select idle intercom path and depress intercom
button.
(3) On the 6Al console, momentarily depress
button on DSS field corresponding to desired
station-tone burst signals called station.
(4) Announcement may now be made to called
party.
4.87
If called party may be reached at another
station, proceed as follows:
(1) Momentarily depress RECALL button on DSS
console-dial tone will be returned.
(2) Momentarily depress button on DSS field
corresponding to desired station-tone burst
signals called party.
(3) Announcement may now be made to called
party.
Page
63
