(2) Pry apparatus blank off locating pins (located
below and to the right edge of key strip).
(3) Press privacy release button (651D key) on
locating pins.
(4) Connect leads according to Table H.
(5) Install designation strip in key cap.
4.69
Where privacy release is no longer required,
the privacy release button may be disabled.
See Table I or
J
for connections.
K. Recall
4.70
Recall provides the same functions as
switchhook flash without restoring the line
buttons. Recall is accomplished by depressing the
RECALL button on the telephone set. The RECALL
button is designated with an amber cap.
C a u t i o n : If C O/PBX lin e s a r e
conferenced and the RECALL b utton
is depressed, the conferenced lines
may be disconnected.
4.71
A recall button, D-180591 kit of parts, must
be added to an 832A or 2832A telephone set
if this feature is required. All other 832- and
2832-type telephone sets are factory-equipped with
a RECALL button.
4.72
The D-180591 kit of parts (recall button) is
mounted in the 832A or 2832A telephone set
and connected as follows:
(1) Remove faceplate.
(2) Pry apparatus blank off locating pins (located
below and to the right edge of key strip).
(3) Press recall button (651F key) on locating
pins.
( 4) Connect leads according to Table K.
(5) Install designation strip in key cap and install
amber key cap on RECALL button.
4.73
The 832A and 2832A telephone sets equipped
with RECALL buttons are electrically
equivalent to the 832/2832B, BM, and DM telephone
sets.
ISS 3, SECTION 5 1 8-450- 1 00
L.
Speakerphone
4.74
Normal speakerphone service may be provided
at all stations in the system.
Connect
speakerphone as follows:
Men installing a 3B or
4A
speakerphone
in conjunction with a modular 832-
or 2832-type telephone set, determine
if there is an orange (0) lead on
terminal 27 of the telephone set
terminal board.
If there is, move
it to termin a l 22.
Failure to
m o ve this lead will cause the
telephone set dial to he inoperative
when the speakerphone is in use.
38 Speakerphone
4.75
Connect the D10R cord between the telephone
set and 55B control unit. Connect the 666B
transmitter, 760A loudspeaker, and 2012B transformer
to the 55B control unit. See Table L for connections.
Plug 2012B transformer into ac receptacle. (Refer
to Section 512-620-487 for illustrations and additional
information on 3B speakerphone connections.)
4A Speakerphone
4.76
Install 223A adapter within cord length (7
feet) of telephone set. Connect M16C cord
to telephone set as shown in Table M.
Plug
loudspeaker, transmitter, and power cords into
223A adapter.
Plug 85B1 power unit into ac
receptacle.
( Refer to Section 512-740-471 for
illustrations and additional information on 4A
speakerphone connections.)
Note:
Speakerphone does not prevent normal
use of the telephone set for originating,
receiving, or transferring calls.
4.77
To originate a call using speakerphone:
(1) Depress CO/PBX button associated with an
idle line.
(2) Momentarily depress transmitter ON button.
ON lamp lights and dial tone is heard through
the loudspeaker.
(3) Dial number in normal manner.
(4) When called party answers, transmitter and
loudspeaker are used to carry on the
conversation. Adjust volume level as desired.
Page 59
