2.5” (65mm)
Fig. 3a
1. Place the Wall Plate flat against the wall with the center of the Wall Plate in the desired location,
Use the Wall Plate as a template to mark the locatioin of the two mounting holes on the wall.
Make sure that the mounting holes are level and are parallel. Make sure the holes are no closer
than 16” apart.
2. Use 3/8” (10mm)
drill bit to pre-drill holes at least 2.5” inches (65mm) deep at the marked
locations. (Fig 3a)
3. Insert a Wall Anchor (5) into each pre-drilled hole and lightly tap it with a hammer until the
Wall Anchor is flush with the wall.
4. Use a wrench, the two Lag Bolts (4) and M8 Washers (6) to attach the Wall Plate to the wall.
5. Use the magnet level placed on the front of the Wall Plate to level the mount, repositioning as
necessary, then firmly tighten the bolts.
Concrete wall
6
6
4
4
5
5
Summary of Contents for XD6220
Page 2: ...ATAK ...