ATAGO 3574, Instruction Manual

Page: 26 / 57

24
(3) Change from Brix Mode to nD
①
During measurement, the READING light blinks,
and the display will show Brix (%) readings (Fig.
10-4).
By pressing the START/STOP key, the READING
light will turn off, and "StoP" will display, ceasing
measurement (Fig. 10-2).
The "Brix (%)" light will remain illuminated.
②
Press SCALE until the "nD" light blinks, indicating
refractive index mode is selected. Fig. 10-4
③
Press ENTER to confirm this selection.
The "nD" light will remain illuminated.
④
Press START/STOP to resume measurement.
The READING light will blink and measurements
will be displayed as nD values (Fig. 10-5).
Fig. 10-5
(4) Change from Brix Mode to Conc
①
During measurement, the READING light blinks,
and the display will show Brix (%) readings (Fig.
10-4).
By pressing the START/STOP key, the READING
light will turn off, and "StoP" will display, ceasing
measurement (Fig. 10-2).
The "Brix (%)" light will remain illuminated.
②
Press SCALE twice and the "Conc" light blinks,
indicating Conc1 mode is selected.
After “Conc1” is
displayed, the last value will be displayed.
③
Press ENTER to confirm this selection.
The "Conc" light will remain illuminated.
↓ 0.5sec
④
Press START/STOP to resume measurement.
The READING light will blink, and measurements
will be displayed as Conc1 values (Fig. 10-6).
In case of a concentration scale (Conc) not
programmed, "- - - -" will display.
Fig. 10-6
Conc1