Atag VA98211TT, Operating Instructions Manual

Page: 51 / 64

Troubleshooting
Action Type of fault Display
Call the service division. Overfilling
See "Water remains in the dishwasher" in the table
below.
Water outlet fault
Check that the water tap is on. Water inlet fault
Turn off the water tap and call the service division. Inlet valve leakage
Turn off the machine with the On/Left-on mode button and then turn it on again to clear the error message from the display.
Action Possible causes Problem
Remove the arms and clean them. The spray arms do not rotate. The dishes are not clean.
Check that the dishes are not blocking the
spray arms.
Avoid large packages. Old detergent. Detergent is a perishable
product.
Dose according to water hardness. Far too
much or far too little detergent results in
poorer dishwashing results.
Incorrect detergent dosage.
Select a higher temperature or a more
powerful programme.
Dishwashing programme too weak.
Do not cover porcelain with large bowls or
the like. Avoid placing very tall glasses in the
corners of the baskets.
Dishes loaded incorrectly.
Place dishes to sit steady. Glasses and cups have toppled over during
the programme.
Screw the filter firmly into place. See the
section Care and cleaning.
The filter is not correctly fitted.
Check that the salt compartment lid is
properly tightened. Otherwise call the service
division.
The water softener is leaking salt. Spots or films on the dishes.
See the section Settings. Incorrect water softener setting.
See the sections Before washing for the first
time and Settings.
Incorrect rinse aid dosage setting.
Top up with salt. See the section Before
washing for the first time.
Salt compartment empty.
Inactivate the setting TAB (3-in-1/ All-in-one
detergent) and top up salt and rinse aid.
3-in-1/ All-in-one detergent is used and the
setting TAB (3-in-1/ All-in-one detergent) is
activated.
Wash crystal at a low temperature and with
a conservative amount of detergent. Contact
the detergent manufacturer.
Too high temperature and/or too much
detergent can cause etching on crystal.
Unfortunately, this cannot be repaired, only
prevented.
Reduce the amount. See the sections Before
washing for the first time and Settings. If you
have very soft water, you may want to dilute
the rinse aid 50:50 with water.
Rinse aid dosage setting too high. The dishes have a sticky white/blue film.
17