Drainage pump
The pump can be accessed from inside the dishwasher.
1. Cut the power to the dishwasher by pulling out the
plug from the wall socket!
2. Remove the coarse filter and pipe section.
3. Remove the small yellow fitted piece at the left of the
bottom drain (see illustration below).
4. By inserting your finger into the hole you can turn the
pump blade to release anything blocking it.
5. Reinstall the fitted piece and filters.
6. Plug the machine in again.
If the dishwasher still does not start and a whirring
sound is heard, the overflow protection has been
activated.
•
Shut off the water.
•
Remove the plug from the wall socket.
•
Call the service division.
NOTE!
Do not forget to reinstall the fitted piece.
Lower spray arm
Holes and bearings can sometimes become blocked.
1. Pull the lower spray arm straight up to release it.
2. Remove any debris using a needle or the like. The
spray arms also have holes underneath.
Upper spray arm
1. Pull out the basket.
2. Unscrew the spray arm bearings as illustrated to
remove the spray arm from the upper basket.
Spray arm bearings
3. Clean the upper spray arm in the same manner as the
lower spray arm.
4. Replace the spray arm and screw the spray arm
bearings firmly back into place.
26
Care and cleaning
