Atag VA3013RT, Operating Instructions Manual

Page: 24 / 32

Action Possible causes Problem
Clean the coarse and fine
filters. The filters are blocked. Water remains in the
dishwasher.
Clean the drainage pump.
See the section Care and
cleaning. Debris in the drainage
pump.
Check that the hose is free
from kinks and sharp bends. Kink in drainage hose.
Disconnect the drainage
hose where it connects to
the sink unit's water trap.
Check that no debris has
fastened and that the
connection has an inner
diameter of at least 14 mm. Blocked drainage hose.
Clean with washing-up
brush and low foaming
cleaner. Dirt around the seals and in
corners. Bad odour in dishwasher.
Run a programme with a
higher temperature about
once a month. Low temperature
programmes have been
selected for a prolonged
period.
Activate the Auto open
option. The Auto open option is not
activated. The dishes are not dry
enough.
Fully load the dishwasher. The dishwasher is not fully
loaded.
Top up with rinse add or
increase the rinse aid
dosage. See the sections
Before washing for the first
time and Settings. Rinse aid needs topping up
or dosage is set too low.
Inactivate the setting TAB
(3-in-1/ All-in-one detergent)
and top up salt and rinse
aid. 3-in-1/ All-in-one detergent
is used and the setting TAB
(3-in-1/ All-in-one detergent)
is activated.
24