Atag VA3013RT, Operating Instructions Manual

Page: 23 / 32

Action Possible causes Problem
Check that the salt
compartment lid is properly
tightened. Otherwise call the
service department. The water softener is
leaking salt. Spots or films on the dishes.
See the section Settings. Incorrect water softener
setting.
See the section Settings. Incorrect rinse aid dosage
setting.
Top up with salt. See the
section Before washing for
the first time. Salt compartment empty.
Inactivate the setting TAB
(3-in-1/ All-in-one detergent)
and top up salt and rinse
aid. 3-in-1/ All-in-one detergent
is used and the setting TAB
(3-in-1/ All-in-one detergent)
is activated.
Wash crystal at a low
temperature and with a
conservative amount of
detergent. Contact the
detergent manufacturer. Too high temperature and/or
too much detergent can
cause etching on crystal.
Unfortunately, this cannot
be repaired, only prevented.
Reduce the amount. See the
sections Before washing for
the first time and Settings. If
you have very soft water,
you may want to dilute the
rinse aid 50:50 with water. Rinse aid dosage setting too
high. The dishes have a sticky
white/blue film.
Use a detergent with a
bleaching agent. Lipstick and tea can be
difficult to wash off. Spots left after washing.
The detergent compartment
must be dry when adding
detergent. The detergent compartment
was damp when adding
detergent. Detergent residue in the
detergent compartment after
dishwashing.
Check that the dishes are
placed securely. Spin the
spray arms to make sure
they can rotate. The dishes are not correctly
placed or the spray arms are
not rotating. Rattling sound when
dishwashing.
23