ata
Automatic Technology America
VIneyard Centre II, 1452 Hughes Road, Grapevine, Texas 76051, United States of America
P: +1 817 873 5076 W: www.automatictechnology.com
Preparation of Opener
a. Disconnect the power supply to the opener.
b. Remove the back cover via screw at top.
c. To connect the harness remove the side flap from the side of cover.
Slide the WBS harness 3
1
/
2
inches
6
through the slot in the cover.
Connect the harness to the 4 pin connector on the control board as
shown on the control board.
d. Refit the covers.
Mount and connect Transceiver
a. Plug the other end of the harness into the wireless basestation
5
.
b. Connect the wireless basestation to opener by sliding the aerial from
the wireless basestation
5
through the slot in the cover as shown
so that aerial hangs out of cover. Affix wireless basestation to opener
with 1 x Taptite screw
8
.
WARNING! DO NOT drill into the chassis or covers. A
predrilled hole exists to secure the wireless basestation.
Test the Opener
a. Reconnect power to the opener and test operation.
b. Upon completion of a full cycle the lock will engage into the track.
Back cover screw
4 Pin Connector
6
Aerial slot
Affix with screw here
Not available with AM-800
Connect Wireless Basestation to Opener
AM-808 and AM-888
8
5
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following
two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.