Auto-Lock Installation Instructions
2
ata
Preparation - pull tab
a. Prior to installation of the Auto-lock, pull to remove the battery isolation tab.
b. Once removed the battery will engage and the lock is operational.
Examine the garage and proceed to either Standard or Limited Sideroom Installation.
IMPORTANT WARNING:
• DO NOT attempt to disassemble, repair or modify the
product. This will invalidate the warranty.
• DO NOT allow children to play with the Auto-Lock.
• Not suitable for garages that have only one exit.
• DO NOT cover, paint or lubricate the product.
Fail Safe -
When the battery within the Auto-Lock is running low the operator will flash three times at each cycle and
it will keep the lock in the open position until the batteries are replaced. This will ensure that the Auto-Lock
will not remain locked when the batteries run out.
Fail Secure -
When a power failure occurs the Auto-Lock will remain in the state it is in when the power failure occurs.
Therefore the power interuption does not interfere with the status of the Auto-Lock. If battery backup is
installed the Auto-Lock will operate as per normal.
Preparation
Important Safety Instructions
WARNING!
• DO NOT attempt to disassemble, repair or modify the product.
This will invalidate the warranty.
• Do not allow children to play with the Auto-Lock.
• Not suitable for garages that have only one exit.
CAUTION:
Fall from ladder
• Ensure ladder is the correct type for job.
• Ensure ladder is on flat ground.
• Ensure user has 3 points of contact while on ladder.
Burns
• DO NOT handle damaged or leaking batteries
• The Auto-Lock Kit contains sealed lead-acid batteries that must be disposed of properly at
the end of their useful life.