XSDC 601-02
4.9 Door alarm
The alarm delay for a door alarm has been preset to 90 seconds, and does not allow for modification.
In the event doors are opened for longer periods, the alarm will activate an acoustic signal, the
display backlight will change to blinking red, and switch on the signal lamp flashing red, if provided.
Briefly pressing the [SET]-button will serve to acknowledge the audible alarm. It will then be
reactivated for new alarms. Both, the alarm signal on the display as well as the signal light are
automatically deleted upon correction of respective alarm causes.
4.10 Interlocking (key-lock display)
Simultaneously pressing the buttons [+] [-] for 5 seconds will cause the indication "Interlocking
Activated" to appear on the display. The control system is now protected from unintended parameter
re-adjusting. Currently set parameters can be viewed but not modified. If you request to modify the
settings, please press the buttons [+] [-] for another 5 seconds, until the display indicates "Unlocked".
All functions can be re-accessed unrestrictedly again.
4.11 Changing the standard IP address from the cabinet
Default IP settings:
The IP setting cannot be used with a local DHCP server, so the IP address need to be set manually
The Standard IP setting is:
BM (base Module) IP address: 10.31.0.xxx
TDE (display) IP address:
10.31.0.xxx
Subnet mask:
255.255.255.0
Gateway:
10.31.0.1
Choose your own IP address:
Before starting with this procedure please determine 2 IP addresses which can be used for the cabinet
in your local network, and write them down below:
BM (base Module) IP address: __________________
TDE (display) IP address:
__________________
Subnet mask:
__________________
Gateway:
__________________
If you do not know which IP address can be used please ask your local IT administrator.
