1-2
Chapter 1: Product introduction
Internal DC power connector (2-pin ATX19V/12V)
This connector is for an ATX power supply. The plug
from the power supply is designed to fit this connector
in only one orientation. Find the proper orientation and
push down firmly until the connector completely fits.
PIN 1
ATX19V/12V
DC_JACK_IN
GND
CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN )
Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside
the system may damage the motherboard components. These are not jumpers! Do not
place jumper caps on the fan connectors! The CPU_FAN connector supports a CPU fan
of maximum 1A (12 W) fan power.
Serial ATA 6.0Gb/s connectors (SATA6G_3~6)
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA
6.0 Gb/s signal cables.
USB 3.0 connector (20-1 pin USB3_12)
Connect a USB 3.0 module to this connector for additional USB 3.0 front or rear
panel ports. This connector complies with USB 3.0 specifications and provides
faster data transfer speeds of up to 5 Gbps, faster charging time for USB-
chargeable devices, optimized power efficiency, and backward compatibility with
USB 2.0.
DDR4 SO-DIMM slots
Install 2 GB, 4 GB, 8 GB, and 16 GB non-ECC un-buffered DDR4 SO-DIMMs into
these DIMM sockets.
SATA power connector (15-pin SATA_PWRCON)
This connector is for the SATA power cable. The power cable plug is designed to
fit this connector in only one orientation. Find the proper orientation and push down
firmly until the connector completely fit. To provide power to your SATA device,
connect the SATA power cable to this connector
Panel voltage selection header (VCC_PWR_SEL)
3
3V
(Default)
2
5V
1
12V
VCC_PWR_SEL
Panel off header (2-pin PANEL_OFF)
This 2-pin header is for connecting a monitor switch that can turn off the LCD panel
display backlight.
Speaker connector (4-pin SPEAKER)
This 4-pin connector is for the chassis-mounted system warning speaker. The
speaker allows you to hear system beeps and warnings.
Pins
Setting
1 (Default)
3V
2
5V
3
12V
Summary of Contents for Q170T
Page 1: ...Motherboard Q170T ...
