1-24
Chapter 1: Product introduction
3.
ATX power connectors (24-pin EATXPWR, 4-pin ATX12V)
These connectors are for ATX power supply plugs. The power supply plugs are
designed to fit these connectors in only one orientation. Find the proper orientation and
push down firmly until the connectors completely fit.
•
For a fully configured system, we recommend that you use a power supply unit (PSU)
that complies with ATX 12 V Specification 2.0 (or later version) and provides a minimum
power of 400 W.
• Do not forget to connect the 4-pin ATX12V power plug. Otherwise, the system will not
boot.
• We recommend that you use a PSU with a higher power output when configuring a
system with more power-consuming devices or when you intend to install additional
devices. The system may become unstable or may not boot up if the power is
inadequate.
4.
Serial ATA connectors (7-pin SATA1-6)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives.
Connect the right-angle side of SATA signal cable to
SATA device. You may also connect the right-angle
side of SATA cable to the onboard SATA port to avoid
mechanical conflict with huge graphics cards.
right angle side
P5QL-CM
P5QL-CM ATX power connectors
EATXPWR
PIN 1
GND
+5 Volts
+5 Volts
+5 Volts
-5 Volts
GND
GND
GND
PSON#
GND
-12 Volts
+3 Volts
+3 Volts
+12 Volts
+12 Volts
+5V Standby
Power OK
GND
+5 Volts
GND
+5 Volts
GND
+3 Volts
+3 Volts
ATX12V
PIN 1
+12V DC
+12V DC
GND
GND
P5QL-CM
SATA2
GN
D
RSATA_RXN2
RSATA_RXP2
GN
D
RSATA_TXN2
RSATA_TXP2
GN
D
SATA4
GN
D
RSATA_RXN4
RSATA_RXP4
GN
D
RSATA_TXN4
RSATA_TXP4
GN
D
SATA6
GN
D
RSATA_RXN6
RSATA_RXP6
GN
D
RSATA_TXN6
RSATA_TXP6
GN
D
SATA1
GN
D
RSATA_RXN1
RSATA_RXP1
GN
D
RSATA_TXN1
RSATA_TXP1
GN
D
SATA3
GN
D
RSATA_RXN3
RSATA_RXP3
GN
D
RSATA_TXN3
RSATA_TXP3
GN
D
SATA5
GN
D
RSATA_RXN5
RSATA_RXP5
GN
D
RSATA_TXN5
RSATA_TXP5
GN
D
P5QL-CM SATA connectors (ICH10)
Summary of Contents for P5QL-CM
Page 1: ...Motherboard P5QL CM ...