2-16
Chapter 2: Basic installation
3. Connect one end of the
supplied 7-pin SATA cable
to the SATA connector at
the back of the drive, then
connect the other end to
a SATA connector on the
motherboard. See page 4-7
for the location of the SATA
connectors.
4. Connect the 15-pin SATA power
plug from the power supply unit
to the power connector at the
back of the drive.
5. Place the HDD on the tray.
Make sure that the HDD
screws are aligned with the
screw holes and rails.
6. When the HDD screws align
with the screw rails, push
the drive carefully until it is
completely flushed on the bay.
The HDD screw lock clicks
to indicate that the drive is
properly in place.
HDD screw lock
