Asus AAEON BOXER-6710, User Manual

Page: 20 / 75

Chapter 2 – Hardware Information 7
Fa
nl
es
s E
m
be
dd
ed
B
ox
P
C
BO
XE
R-
67
10
2.3 List of Jumpers
Please refer to the table below for all of the system
’ s jumpers that you can configure
for your application
Label Function
JP5 AT/ATX mode select
JP10 Clear CMOS
2.3.1 Setting Jumpers
You configure your card to match the needs of your application by setting jumpers. A
jumper is the simplest kind of electric switch. It consists of two metal pins and a small
metal clip (often protected by a plastic cover) that slides over the pins to connect them.
To “close” a jumper you connect the pins with the clip.
To “open” a jumper you remove the clip. Sometimes a jumper will have three pins,
labeled 1, 2 and 3. In this case you would connect either pins 1 and 2 or 2 and 3.
1 2
3
Open Closed Closed 2-3
A pair of needle-nose pliers may be helpful when working with jumpers.
If you have any doubts about the best hardware configuration for your application,
contact your local distributor or sales representative before you make any change.
Generally, you simply need a standard cable to make most connections.