9
T
RIGGER INPUT
Your remote starter is equipped with a negative trigger (pulse) input.
This input can be connected to another remote control device or to an AstroStart RST-2 timer
output (optional), part number 310-903-502.
If this input is connected, consult this device's manual or ask your technician which command
controls the Start/Stop function.
Commands received on this input are ignored while engine is running on a remote start.
All Start/Stop commands triggered on the input act the same as a remote control commands.
CONTINUOUS MODE
Continuous Mode function lets you remove the key from the ignition while leaving the engine running. This convenient
feature allows you to leave your vehicle for short periods while climate controls remain on.
A
UTOMATIC
TRANSMISSION
VEHICLES
To access Continuous Mode, send Start command while engine is idling (see S
TARTING THE ENGINE
on page 8). Parking lights, engine and climate controls will remain on for the duration of the
programmed runtime.
M
ANUAL
TRANSMISSION
VEHICLES
To access Continuous Mode, send Start command before removing the key from ignition when
performing the safety sequence described on page 3. See “STARTING the ENGINE“ on page 8.
Note: Do not send the stop command if you perform sequence activated by the remote control (Step
7).
Remove the key, exit vehicle and lock all doors. All safety devices will remain active.
If you return to your vehicle before runtime has elapsed, just turn the key to
RUN position
and press the brake pedal.
W
HAT STOPS THE ENGINE
For your safety, engine will not start or will stop if:
Your key is in ignition (prevent Start cycle).
Remote control sends a Stop message.
Hood is open.
Brakes are applied.
Engine is over-revving (if programmed Enable at installation).
Alarm detect intrusion.
Main switch is
OFF
.
Safety sequence not valid (manual transmission vehicle only - parking brake not applied, opening of door detected
while remote starter was not keeping engine running).
M
AIN SWITCH
The main switch is usually mounted under the dashboard. It is a toggle
ON
/
OFF
switch that
is used to cancel start functions.
It does not disable other commands, which remain active (Alarm features, Locks, etc.).
STOP
When engine is running on a remote start, you can turn it
off by performing a stop command.
This command also terminates panic mode and the alarm condition without disarming the security system.
4-
BUTTON REMOTE CONTROL
5-
BUTTON AND
6-
BUTTON REMOTE CONTROLS
