QL-850 User Guide
107
8
External Unwinder
Before Installing the External Unwinder
Before installing the unwinder, observe the following precautions.
•
No unwinder feet should float. The unwinder must be held level constantly.
•
The unwinder must be installed on the same plane as the printer.
•
The unwinder weighs 25 pounds (11.3 kilograms). When placing the unwinder on a desk,
table, or other similar surface, it must be sturdy and stable enough to support the weight
of the printer, unwinder, and roll media. A table that can support at least 150 pounds (68
kilograms) is recommended.
•
The unwinder and associated bracket require a surface 43 inches (1093 mm) in length
and 21 inches (534) in width.
•
If you are installing both the rewinder and unwinder, a surface 51 inches (1296 mm) in
length and 21 inches (534 mm) in width is required.
•
Do not turn the unwinder mandrel by hand to unwind the media. Turning the mandrel by
hand can result in unwinder damage.
Summary of Contents for QuickLabel QL-850
Page 1: ...U S E R G U I D E...
