5.2
Setting the IP Management interfaces
The „IP Management Settings“ area is used to stipulate the DNS server, to configure up to four
SNMP Trap recipients and to input two SNTP servers for obtaining the time reference. The time
source used may then be „SNTP Server“ or „IP Rx 1“ to „IP Rx 16“ or „ASI TP“. Only the licensed
„IP Rx“ can be used.
Figure 5: Detail from the basic settings of the U 262 „IP Management Settings“
NOTE:
Please use different IP addresses. Input 0.0.0.0 for unused or unknown DNS, SNMP or SNTP
addresses.
5.3
Storing and loading settings / reboot
The „Save“ button is used to save all settings made in the flash memory and to restore them even
after mains failure or a reboot. The „Load“ button is used to restore the last operating parame-
ters saved in the flash memory and to reject changes which were made previously and were not
stored.
Figure 6: Detail from the basic settings of the U 262 „Save, Load, Default & Reboot“
„Default“ is used to restore the factory settings, and „Reboot“ prompts the advice to restart with
the operating parameters saved in the flash memory.
10
User Guide U 262
