Operation
900285-01 08/2016
Innovative Hearth Products
Gemini™ and GeminiCD Series Direct-Vent Gas Fireplaces
57
Installing 40” and 45” logs
The logs have notches/tabs to assist proper positioning. Upper logs rest on lower logs via notches/tabs. Proper log
placement is critical to prevent sooting. Place the logs in the gaps between fl ame peaks, so they do not impinge the
fl ames. Follow the log placement instructions precisely.
NOTE:
Do not cover the burner ports.
Table 39 - 40” and 45” Log Sets
Log Number
Description
1
Rear Left Log
2a
Center Log
2b
Center Log Attachment
3
Right Front Log
4
Left Front Log
1
3
2b
4
2a
NOTE: Fireplace shown with optional brick panels.
1.
If necessary, remove the glass door
(
Page 58
)
. Locate and bend up the log placement brackets
(
Figure 54
).
Figure 54 - Locating the log placement brackets
Figure 55 - Placing logs 1 and 2a
Burner Slots Do Not Obstruct
Left and Right Rear Log Bracket
Left Front Bracket
Right Front Bracket
2.
Position rear left log (1) on the left rear log bracket
(
Figure 55
)
3.
Position the center log (2a) against the log grate and to the rear of the fi replace
(
Figure 55
)
.
Figure 56 - Placing log 2b
Figure 57 - Placing log 5
2b
2a
3
2a
1
4.
Position the center log attachment (2b) at the right end of the center log (2a)
(
Figure 56
)
.
5.
Position the right front log (3) on the center log attachment (2b) and the left front log (4) over the center log (2a)
(
Figure 57
)
.
NOTE
: It is important to ensure proper log placement per the
manual when installing these units. Verify pilot fl ame is not
obstructed. See Verifying Appliance Operation on
Page 41
.
Catalog number for the entire set:
F2194
-
40” Models
F2196
-
45” Models