NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
15
CHECKING APPLIANCE OPERATION
With gas line installed run initial system check-
out before installing any additional accessories.
Follow the lighting instructions on Page 21.
NOTE: Lighting Instructions are also found
on the literature tag tied to the gas piping
next to the gas valve. To access the tag,
open the lower control compartment door
(refer to Figure 13, Page 10 - Valve Access).
When first lighting the appliance, it will take a few
minutes for the line to purge itself of air. Once
purging is complete, the burner will light and
operate as indicated in the instruction manual.
Subsequent lighting of the appliance will not
require such purging. Inspect the pilot flame
(remove logs, if necessary, handling carefully).
After the logs have been placed and the fireplace
has been checked for proper flame presentation.
Electronic Appliance Checkout
Carbon Monoxide Poisoning: Early signs
of carbon monoxide poisoning are similar
to the flu with headaches, dizziness and/
or nausea. If you have these signs, obtain
fresh air immediately. Turn off the gas sup-
ply to the appliance and have it serviced by
a qualified professional, as it may not be
operating correctly.
Figure 24 - Clearances To Combustibles
6 (153) Minimum
For Combustible
Materials
See Note
3-3/4 (95)
Max.
NOTE: The area above the face to the top of the spacers
must be non-combustible materials.
5 (127)
Min.
Mantel
Review mantel clearances
Figure 11, Page 9
FIREBOX FINISHES
Only noncombustible materials like marble,
stone, tile, brick, etc. may overlap the top and
sides of the front facing. Seal all joints between
the black facing and wall surrounds to prevent
air intrusion.
Use noncombustible caulking materials only to
seal the metal facing to the surround material
on the finished wall. See Figure 24.
CAUTION: DO NOT BLOCK THE FACE OPEN-
ING ON THESE FIREBOXES. DOING SO MAY
CREATE A POTENTIAL FIRE HAZARD.
