NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES
7
Door gasket instructions
1
. Reinstall the door. If the door does not fully close easily,
the door gasket will need to be dressed. See
Figure 21
and
Warning below.
Correctly dressed Gasket.
Screwdriver works well
to dress gasket.
WARNING
The door should easily close without needing to
be pressed down. If it has to be pressed down to
close, the gasket in the top of the door should be
dressed so it lays on the glass.
Correctly Dressed Gasket
Improperly Dressed Gasket
Improperly dressed gasket.
No gap between gasket
door channel.
Clean porcelain panels (if applicable)
1.
If applicable, use non-ammoniated glass cleaner and a soft
rag to remove fi ngerprints and smudges from porcelain
panels and fl oors.
Install glass door assembly
1.
Hold the glass door assembly by the sides, and hook the
top edge to the fi replace. Then swing the bottom edge in
toward the fi replace
(
Figure 20
)
.
NOTE:
Be careful not to damage the glass.
2.
Align the screw holes below the door assembly with the
holes in the fi replace, and secure using the (3) provided
screws.
Install baffl e (provided with fi replace)
1.
With the baffl e oriented as shown
(
Figure 19
)
, slide the rear
tabs into the slots in the back panel.
2.
While sliding the tabs into the slots, engage the front lip of
the baffl e under the spring clips in the fi rebox ceiling.
Baffl e
Slots in
Back Panel
Spring Clip
Firebox Ceiling
Tabs
Figure 19 - Installing the baffl e
Figure 20 - Installing the glass door assembly
Figure 21 - Door gasket
Rating plate and lighting instructions
are attached to door bracket.
Glass Door Assembly
f i r e - p a r t s . c o m