Astral Pool LUMIPLUS S-LIM 1.11, Installation And Maintenance Manual

Page: 3 / 24

3
ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be im-
plemented for installation and start-up. Therefore, the installer as well as the user must read the instructions before
beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the LumiPlus S-Lim Projector, follow the instructions provided below:
1. VERIFY THE CONTENTS OF THE PACKING:
The following accessories are included inside the box:
• Unit projector • Warranty booklet
• Crosshead mount • Bag of fastenings
• Installation and maintenance manual • Manual for electrical connection
MODELS AVAILABLE ACCORDING TO CHARACTERISTICS
LumiPlus S-Lim 1.11 LumiPlus S-Lim 2.11
Pool Light
Faceplate
Pool Light
Faceplate
ABS Stainless Steel ABS Stainless Steel
Concrete
RGB
56022 56023
Concrete
RGB
56010 56011
Monocolor
56030 56031
Monocolor
56018 56019
RGB-DMX
56026 56027
RGB-DMX
56014 56015
Prefabricated
RGB
56024 56025
Prefabricated
RGB
56012 56013
Monocolor
56032 56033
Monocolor
56020 56021
RGB-DMX
56028 56029
RGB-DMX
56016 56017
2. GENERAL CHARACTERISTICS:
This projector has been designed to be used totally submerged in water. It is a Class III electric apparatus with very low
safety voltage
(12V with alternating current)
.
The projector compiles with IPX8 degree of protection (resistance to penetration of dust, solid bodies and humidity) at a
nominal immersion depth of 2 m.
This projector compiles with international safety standards for lights, especially the EN 60598-2-18 standard. LIGHTS
PART 2: SPECIFIC REQUIREMENTS SECTION 18 LIGHTS FOR SWIMMING POOLS AND SIMILAR APPLICATIONS.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric components
which have been inserted or handled at locations other than its own premises.
3. INSTALLATION:
• To correctly light a swimming pool we recommend you:
Install a projector in the range LumiPlus 1.11 every 20 m² of water surface.
Install a projector in the range LumiPlus 2.11 every 25 m² of water surface.
Note: Recommendation valid for light coloured pools. In darker coloured pools or stainless steel pools we recommend
oversizing the proportion of projectors per m².
• In order to prevent glare, the projectors should be installed so that they face away from the residence or usual view of
the swimming pool.
• In the event that lighting is used in training or competition pools, the projectors should be installed on the sides to
prevent glare on the swimmers.
• In installations where you want to replace a conventional spotlight by a LED projector, using the existing wiring, it is
strongly recommended to use underwater resin splicing. It is not recommended to use silicone to try to seal the con -
nection point of the wires. The spotlight should not be handled internally under any circumstances as this would lead
to losing the guarantee.
• The projector should be placed on the wall of the pool at approximately 400-700 mm from the water surface (Fig. 5).
The method of fastening the crosshead mount to the pool wall varies depending on whether it is a projector for concrete
pools or prefabricated pools.
• In the LumiPlus 2.11 models it is essential that the direction of the projector is adequate, situating “TOP” on the top.