14
8.
OPERATION MODES
8.1.
BASIC MODE
In this section it is assumed that a successful connection has been established with the Lumiplus and
therefore, address, baud settings and watchdog behavior has been already set.
8.1.1.
START PREDEFINED COLOR/SEQUENCE
The Start Predefined Color/Sequence, is the color or sequence in which will work the Lumiplus when it
Powers ON.
The
High byte
set the
speed
of the sequence, it can take values from 0 to 8. if it is set to 0, the speed
will be 0 which means that a color is fixed.
The
Low byte
sets the
color
if the High byte is 0, or the
sequence
if a different value of 0 is set in the
High Byte. The Low byte can take values from 0 to 12, these are 12 configured colors, or 8 sequences.
If it is set to 0, any light will be ON when the Lumiplus powers ON.
If the register is configured like (0xFFFF), the luminaries remain with the color / sequence previous of
the last OFF.
The way to setting this parameter is the same that the Watchdog predefined color sequence, the only
difference is the number of the holding register, in this case the holding register is 0x15.
In the Start Predefined Color/Sequence and in the Watchdog predefined Color/Sequence, is not
necessary to make a request update to change the color, when the system Starts or, the watchdog
actuates.
Specific color requests and sequences are defined according to the following codification:
Summary of Contents for 57434
Page 3: ...3 ...
