CAUTION:
Do not over tighten fasteners.
1
(SEE FIGURE 1)
Place glass top (A) aside is a safe place until the table
has been fully assembled.
2. Place the table rim (B) upside down on flat non-scratch surface.
3. Turn one table leg (C) upside down and align leg with corner of table rim (B).
4. Place metal washer (G) onto short bolt (E) and insert into previously drilled hole.
Using hex wrench (J) attach leg to table rim. Repeat steps 2 and 3 for remaining table legs.
Do not tighten hardware.
5. Place leg connector bracket (D) between table legs (C).
6. Place lock washer (H) onto long bolt (F) and insert into previously drilled holes of connector
bracket and table leg. Using hex wrench (J) attach connector bracket to each leg. Do not
tighten hardware.
7. With each leg attached to the connector bracket tighten each bolt a few revolutions at a time,
alternating between bolts in a cross corner "X" fashion.
NOTE:
Tightening every other bolt or in a cross fashion will ensure your table is level by
placing equal pressure on each joining bolt.
8. Cover all bolts with plastic bolt cap (I).
9. Turn table frame upright and carefully place the glass top (A) into table rim (B).
10. Adjust table legs as needed using the glides at bottom of each leg. Turn glides by hand until
table is level to the floor.
Your table is now ready to use.
ASSEMBLY INSTRUCTIONS
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
A
B
C
D
H
I
J
F
E
PARTS & HARDWARE LIST
PART #
DESCRIPTION
QUANTITY
Figure 1
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER.
CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
G
A
C
D
B
E
G
I
F
H
I
A
Glass Top
1
B
Table Rim
1
C
Table Leg
4
D
Leg Connector Bracket
1
E
Short Bolts
8
F
Long Bolts
8
G
Metal Washers
8
H
Lock Washers
8
I
Plastic Bolt Cap
16
J
Hex
Wrench
1
Parts Detail
1
2
Glides (Adjustable)
NOTE
: This product is intended for residential, non-commercial use.
