A
Small Bucket
1
B
Medium Bucket
1
C
Large Bucket
1
D
Large Base Bucket
1
E
Electric Water Pump
1
F
Screw Set
3
ELECTRICAL SAFETY INSTRUCTIONS
WARNING!
ELECTRICAL SHOCK.
Read and understand all instructions. Failure to follow all
instructions listed below, may result in electrical shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS.
Grounding Instructions
This fountain must be plugged into a 3-wire, 3-prong outlet that is properly working and has
been installed and grounded in accordance with all local, state or federal codes and ordinances.
DANGER:
IMPROPER INSTALLATION OF THE GROUNDING PLUG CAN RESULT IN A RISK OF
ELECTRICAL SHOCK.
Check with a qualified electrician or serviceman if the grounding instructions
are not completely understood, or if doubt as to weather the product is properly grounded. Do not
modify the plug provided; if it will not fit the outlet, have a proper outlet installed by a qualified
electrician. Do not use any type of adapter with this product.
1.
(SEE FIGURE 1)
Place small bucket (A) on
large base bucket (D) as shown and secure
with screw set (F). Place medium bucket (B) on
large base bucket as shown and secure with
screw set (F). Place large bucket (C) on large
base bucket as shown and secure with
screw set (F). Fill large base bucket (D) with
water; if possible use distilled water to
fill large base bucket. Make sure all the
buckets are facing correctly as shown in
figure 2.
2. Plug power cord of electric pump (E) into
properly grounded 120V AC outlet.
Adjust Speed of Water Flow
1. Unplug pump (E) from AC power outlet.
2. Move adjustment switch on pump (B)
toward "+" positive to increase water
flow, or "-" to decrease water flow.
Maintenance
1. Check water level periodically, add
water if necessary.
2. If water is not flowing, check electric pump (E),
and large bucket (C) water pipe for clogs.
NOTE:
Pump may build up calcium after a
long period of time and stop running when
tap water is used. Any calcium remover can
be used to clean pump.
PARTS & HARDWARE LIST
PART #
DESCRIPTION
QUANTITY
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
ASSEMBLY INSTRUCTIONS
B
C
E
F
D
A
1
2
Parts Detail
AMP Load
Volts Extension Cord Length
120V
25'
50'
100'
150'
AWG
1-5
18
16
16
14
6-10
18
16
14
12
10-12
14
14
14
12
12-16
14
12
Not recommended
Table 1. Minimum Recommended Extension Cord Gauge (AWG) Chart
Outdoor Use Extension Cords.
1. When product is used outdoors, use only extension cords marked for outdoor use.
2. Use only UL listed extension cords. Never use damaged or altered extension cords.
3. Follow extension cord manufacturer safety instruction.
Extension Cords
1. Make sure your extension cord is in good condition.
2. When using extension cords, be sure to use one heavy enough to carry the current your product
requires. An undersized cord will cause a drop in line voltage resulting in power loss and
overheating. Reference Table 1 at the bottom of the page for the correct size to use depending
on cord length and nameplate Ampere rating. If in doubt, use the next heavier gage. The smaller
the gage number, the heavier the cord.
Figure 1
Figure 2
B
A
E
C
F
D
