Aston Technologies Inc.
19
Notice:
Pay attention to the distance of the Head. The distance to up rims of Hook Head
should be made according to the actual size of different tires. For tires with higher flat
ratio, the Hook Head should be a little higher. If it presses too deeply, the bottom bead of
tires cannot drop into the wheel. For the tires with lower flat ratio(soft tires) it can press
relatively more deeply. If it presses too shallow, the bottom bead of tires cannot drop into
the wheel either.
◆
Press motor pedal and make the bottom bead of tires drop into wheel, finishing the lower
tire mount. Pull the Wheel Disk (K) against the rim about 2-4mm as shown in Picture
13-D. Turn down the twist on Hand Control Valve(Z), forcing the Straight Head and
Wheel Disk to press the tire into the center of wheel 3-5mm. Press down on the left
Hand Control Valve, power the block of Left Helper Arm down to the rims 10-12mm as
shown Picture 13-F. (
Notice:
For run-flat tires, please do always according to the
actual condition adjust the position of the Work Heading and the movement of
hydraulic equipment. If the Working Head is not adjusted in right position which
stepping the Pedal, it will tear tires.)Generally when the Center Spindle turns a circle
tire can be mounted. Then turn back the Hook Head, tire pressing roller and block as
shown in Picture 13-F.
Picture 13
-
A
Picture 13
-
B
Picture 13
-
C
Picture 13
-
D
Picture 13
-
E
Picture 13
-
F
