Aston Global ADP-2000L, User Manual

Page: 14 / 24

Aston Technologies Inc. www.astontechusa.com
- 14 -
1. Display Err1 and do not
rotate.
2. Display Err1 and rotate. 1. Starting delay is
damaged.
2. Phase position
generator goes wrong
and main board is
damaged.
3. Power supply voltage
is much lower. 1. Replace delay or power panel.
2. Adjust photoelectric tube
shelf, replace main board.
3. Boost voltage.
Display Err2 and rotate. 1. Do not install the
wheel.
2. Only install rim but
not tire.
3. Temperature indoors
is much lower, wheel
inertia is not good. 1. Install wheel.
2. Install tire.
3. Make sure that temperature
indoors is more than 5
℃
.
Display Err3 Unbalance amount of
wheel is much greater. Replace wheel or self-calibrate
over again.
Display Err4 1. If reversal, phase
position is connected
incorrectly.
2. If corotation, the
position of sensor goes
wrong. 1. Change the phase sequence of
three phases.
2. Adjust the position again or
replace it.
Display Err7 1. Memory is damaged.
2. Signal loses. 1. Replace X24C45.
2. Self-calibrate over again.
Only display invalid value
00-00. 1. Memory X24C45 is
damaged.
2. Lead wire of sensor
breaks or is loose
contact.
3. Memory value loses. 1. Replace it
2. Connect over again.
3. Input over again.
The value of changed range
every rotation is more than
5g. 1. There are sundries in
the tire.
2. Sensor is affected
with damp.
3. The machine is place
unsteadily.
4. Harmful flow disturbs
the machine such as
electric portable drill
and electric welding
machine. 1. Replace tire.
2. Drying it and adjust again.
3. Tighten fang bolts.
4. Eliminate disturb and try
again.
The value of changed range 1. There are sundries in 1. Replace tire.