Specifications
Generating Element:
Moving Coil Dynamic, Neodymium Magnet
Polar Pattern:
Unidirectional (Cardioid)
Frequency Response:
80 Hz - 15 kHz
Output Level:
Power Level:
-54 dB (0 dB = 1 mW per 10 microbars)
Open Circuit Voltage:
-70 dB (0 dB = 1 volt per microbar)
3.2 mV/Pascal
Impedance:
600 ohms
Phasing
Positive Pressure on Diaphragm generates a positive voltage on pin
2 relative to pin 3
Switch:
Low profile
Grille Screen:
Woven Flex-Form™ (hardened steel)
Case:
Die Cast Zinc Alloy
Finish:
Durable rubber textured Gunmetal black
Dimensions:
(See drawing on other side)
SPECIFICATIONS FOR CTM 44
TWO-YEAR LIMITED WARRANTY
Omnitronics, LLC (“ASTATIC”) hereby warrants that this product will be free of defects in material and workmanship for a period of two years
from the date of purchase. In the unlikely event a defect occurs ASTATIC will, at its option, either repair or replace with a new unit of equal or
greater value. You should retain proof of purchase to validate the purchase date and return it with any warranty claim. Return warranty claims
carefully packed, insured and prepaid to the Service Department at the address listed below.
This warranty excludes exterior finish or appearance, damage from abuse, misuse of the product, use contrary to ASTATIC’s instructions or
unauthorized repair. All implied warranties or merchantability or fitness for a particular purpose are hereby disclaimed and ASTATIC hereby
disclaims liability for incidental, special or consequential damages resulting from the use or unavailability of this product.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. Some states do not allow the
exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above exclusions and
limitations may not apply to you.
Note: No other warranty, written or oral is authorized by Omnitronics, LLC.
Architects’ and Engineers’ Specification
The microphone shall be a dynamic cardioid type, low impedance with a wide
range of frequency response, uniform from 80 to 15,000 Hz having an on/off
switch. Output level at 1 kHz shall be - 54 dB (0 dB = 1mW/10 microbars). The
polar response shall show a minimum of -15 dB at 180 degrees between 150 and
4 kHz. The woven steel screen, when attached to the microphone, shall withstand
a drop of 6 feet to a wooden floor without deformation. The microphone case
shall be die-cast zinc alloy. The microphone shall have a length of 6-3/4" ±1/32"
and a maximum diameter of 1-1/8" ±1/64". The microphone shall be finished in a
rubber textured non-reflecting black. A snap-in clamp and zippered vinyl protective
pouch shall be supplied.
The ASTATIC Model CTM 44 is specified.
@ 1 kHz
46873-20-00 / Rev. 12-23-03
