15
There are three ways to enter a position:
By pressing the phone location button
(usually located in the top right corner of the map). This will set
the position identical to the position of the phone, then press the "Set" button
By entering numeric values for the longitude and latitude of the driver and then pressing the "Set" button
Holding your finger at the current position of the marker will put it in a mobile state, after selecting the
appropriate place, press the "Set" button
CAUTION!!! - Astronomical switch-on and -off times of the outputs depend on the correct position of the driver.
5.5.3
Output operating time
The AST midi driver registers independently the switch-on time of the A, B and C outputs. Values of the outputs'
operating time can be found on the "START" screen. In order to reset the operating time of the outputs, press the time
value for the selected output, which will display a dialog box with information about the confirmation of the operation
of resetting the switching time for the selected output.
5.6
Output mode
The ASTmidi / ASTmidi GPS driver is equipped with two relay outputs with a NO contact. The A, B and C outputs are
programmable independently and can be in one of the four states:
AUTO – the output works automatically according to set intervals of switching on and off for each day of the
week.
