REMOVE THESE
PARTS FOR:
8015: steps 3-4
8016: steps 3-4
TOOLS USED
step 3
STEERING LINKAGE
Install the plastic ball cups onto the #1405 titanium steering
turnbuckles. Match the length of the turnbuckles to the actual
size picture below.
Snap one ball cup onto the ball end on the servo saver. Snap
the opposite end on as shown. Install both turnbuckles.
When you are adjusting your turnbuckles, always make sure
that the servo saver is pointing straight down.
1:1
step 4
FRONT BUMPER
Bolt the #8303 front bumper to the front of the
chassis with two #6942 blue screws from
underneath and two #3438 locknuts on top.
FRONT BODY MOUNT POSTS
Tighten the #8304 body posts to the bumper
where the two gray arrows indicate with two
#6942 blue screws from underneath.
Cut and trim the foam bumper with a sanding
block to fit the body of your choice and slide it
over the two body mounts.
Add #6332 body clips to the front posts and the
rear.
6274
6274
2.40"
6274, qty 4
ball cup
14
1405, qty 2
blue titanium steering turnbuckle
1:1
6332, qty 4
body clip
1:1
6942, qty 4
8-32 x 1/2
blue aluminum
8304, qty 2
front body mount
1:1
8303, qty 1
front bumper
1:1
3438, qty 2
8-32 locknut
3
8305, qty 1
foam bumper
6332
Your kit includes an
extra hole for an optional
body post for those bodies
that require support
for the hood
6942
blue
8304
1405
8303
6942 blue screw
3438 locknut
6942 blue screw
3438 locknut
