Wiring
Please, wire your module as on the picture, with the ribbon cable. There are 4
possibilities, only one is good, the one of the picture, pay attention !
Fonctionning
The LEDs (green and red) reproduce the behavior of those on the midi board.
The "Channel" button replaces its counterpart on the midi board. So, to know the
current MIDI channel on the map, press the Channel button and count the number of
ignitions of the red LED.
To change the channel, press the "Panic" button and simultaneously press the
"Channel" button a number of times equal to the desired Midi channel.
The Midi Assistant is designed for intuitive use, there is no screen because it is not
necessary, you'll clearly see in use.
Using buttons «Play», «Up» and «Down»
•
normal mode:
By pressing the "Play" button, we make the first output of the Midi board play, the
red LED lights up. If you press "Play" button until the red LED turns off (about 2
seconds), the output will remain on, even if you release the button. So you have both
hands free to tune the pipe. To stop it playing, you must re-press briefly the "Play"
button.
To move to the next note, press "Up", and "Down" to the previous one. After the
32th it will pass to the 1st, and vice versa.
