1. Prior to installation of base, we suggest you assemble the desk and
place within the vehicle to establish optimum mounting position. Once
established, disassemble and build as follows.
2.
Place universal base in position and attach base to floor using self-tapping
tech screws.
3. Adjust 7/8” post in base to a vertical position and tighten.
4. Loosen knob on brace collar and slide collar up the vertical tube starting
from the bottom. Position brace kits in desired location and tighten brace
collar.
5. Slide vertical tube assembly onto mount post. Use 2 hex head cap screws
and 2 lock washers to secure vertical tube to mount post.
6.
Position brace kits in the desired location and attach to floor using self-
tapping tech screws.
7. Place articulated swing arm over the 5/8” end of the telescoping rod.
Tighten with ratchet handle.
8. Attach desktop to end of articulated swing arm and secure by tightening
ratchet handle.
INSTALLATION PROCEDURE
READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION
STAND ASSEMBLY OPERATION
1. Remove Hex Head Cap Screws from
stand assembly and place tube over
the Mount Base.
2. Thread (2) Hex Head Cap Screws
with (2) Lock Washers through tube
and into front and rear of Mount post
at bottom of tube. (A)
3. Raise inner rod to desired height.
Thread (2) Hex Head Cap Screws
with (2) Lock Washers into front and
rear holes at top of tube. (B)
4. Use provided Hex Key to tighten (4)
Hex Head Cap Screws to ensure
secure positioning.
RATCHET CLAMP OPERATION
B
A
Insert the ratchet handle through the
unthreaded side of the articulated swing
arm and tighten. Going through threaded
side first will not allow the arm to tighten
properly
To adjust, pull handle out (B) and rotate
counter clockwise (A), release and tight-
en. If needed, use 1/8” hex head wrench
for adjustment (C)
Ratchet handles are spring loaded and
can be readjusted to tighten.
NOTE:
NOTE:
