V3.5 14/08/19
UD0089
Page 693
This Document is uncontrolled unless over stamped "CONTROLLED DOCUMENT"
3.20.10.3.3
CHANGING 16BIT FIRMWARE SETTINGS
The 16bit Configuration Wizard can also be used to make changes to the current system settings and also to unlock
new cost options via a
1.
To open the System Configuration window, from the main screen select the system
and from the system viewer right click over the picture of the relevant
position and click on Configure Firmware.
2.
Click on Next.
3.
If you have a new configuration file to unlock new cost options, select the path to the configuration file. To
search for the configuration file simply click on the Browse button.
NOTE:
The configuration file name is structured as follows…
<Serial Number> - <CPSN Number> - <Firmware Version>.TKCcfg
For example, for a system with a serial number TKC12345, a CPSN of 01041006164704010200 and a
firmware version of 1.00.00, the following file will be required:
12345 - 01041006164704010200 - 010000.TKCcfg
4.
When you have selected the path to the configuration file, click on Next.
If the configuration file was correct the hardware will be licensed to the database and any cost options will
become available.
If the configuration file was incorrect, check that you have the correct file via the file name and try again. An
incorrect file may be may be because…
a.
The CPSN did not match,
b.
The Hardware Key did not match or,
c.
The Firmware Version did not match.
5.
Follow the wizard through, checking ALL the settings and amend as required. For details on the various
settings, please refer to the
6.
Finally click on Finish to save any changes.