Rev. A.4, 12/01
Page- 3
cause a failure to lock properly if the dirt is not regularly cleaned away. Note that when you
bottom mount the SAM,
you have to change two of the springs in the strike assembly
(see
Figure 2).
FIG. 2: SHEAR ALIGNING MAGNALOCK ASSEMBLY (SAM2)
2.2 MOUNTING THE MAGNET BODY
The electromagnet body is mounted first in the door frame. The first step is to set the
approximate position of the magnet body.
Lateral positioning
should be as close to the door
edge as possible when the lock is mounted on the top or bottom of the door.
Centering the
position of the magnet body
is more critical because there is not a lot of free width in the door
frame and door to accommodate any centering error when the SAM is mounted. To set your
Flush Mount Bracket (4)
PN# 390 15960 (US)
PN# 390-16400 (Metric)
.050" Shim Plates (8)
PN# 390-11460
Idle End Bracket (2)
PN# 390-15970
8-32 x 1/2" FHSC Screws (4)
M4-.7 x 12mm
Shear Strike Plate
PN# 380-20010
Strike Shoulder Screw (2)
PN# 300-12408
Strike Compression Spring (2)
PN# 560-13090
Plate Compression Spring (2)
PN# 560-13080 (Standard)
PN# 560-13085 (Floor Mount)
Idle Bracket (1)
PN# 390-15980
