Assa Abloy Sargent SN Series, Installation Instructions Manual

Page: 8 / 24

Copyright © 2020, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
12/31/20
SN200/210 Mortise Lock
A8283A • 800-810-WIRE (9473) • www.sargentlock.com
8
Wiring Diagrams
6
Product 8 PIN CONNECTOR 4 PIN CONNECTOR
1-Black 2-Red 3-White 4-Green 5-Orange 6-Blue 7-Brown 8-Yellow 1-Violet 2-Gray 3-Pink 4-Tan
ACCESS CONTROL DEVICES: SN200/210 Mortise, ElectroLynx wire Color / Function assignments
SN200 12VDC
(Reader)
WIEGAND WIEGAND RX RX EGND GREEN_LED* 12/24 VDC
(LOCK RELAY)
DPS DPS
SN210
OSDP OSDP n/a
SN200 NEG POS DATA_1 DATA_0 NO COM EGND INPUT NEG POS NC COM
SN210 RS-485B RS-485A
n/a
Wiegand Operation Mode:
• Red LED ‘ON’ when powered.
• Presenting a 13.56MHz or 125 kHz credential causes LED to briefly turn green and then return to
red state.
If your lock is configured with End of Line Resistors, reference instruction sheet A8191 for the wiring of
RX & DPS outputs.
*Diagrams on following pages
PIN 3 (Pink – DPS NC)
Note: NC = Normally Closed
NO = Normally Open
PIN 8 (Yellow - GREEN_LED)
PIN 6 (Blue – RX COM)
PIN 4 (Green – RS-485A)
PIN 2 (Red – Reader POS)
PIN 1 (Black – Reader NEG)
PIN 3 (White – RS-485B)
PIN 5 (Orange – RX NO)
PIN 7 (Brown - EGND)
PIN 8 (Yellow – n/a)
PIN 6 (Blue – RX COM)
PIN 4 (Green – Data 0)
PIN 2 (Red – Reader POS)
PIN 1 (Black – Reader NEG)
PIN 3 (White – Data 1)
PIN 5 (Orange – RX NO)
PIN 7 (Brown - EGND)
OSDP Operation Mode*:
*LED/Sounder control and Tamper status communicated over OSDP serial protocol
PIN 3 (Pink – DPS NC)
PIN 4 (Tan –DPS COM )
PIN 2 (Gray – Lock POS)
PIN 1 (Violet – Lock NEG)
PIN 4 (Tan –DPS COM )
PIN 2 (Gray – Lock POS)
PIN 1 (Violet – Lock NEG)
For OSDP cable lengths greater
than 200 ft (61 m) or EMF in-
terference, install 120
Ω
+/- 2
Ω
resistor across RS-485 termina-
tion ends.