18
Copyright © 2012, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
8/05/12
PR100 Exit Devices
5 Install Exit Chassis
Fig. 5A
Inside of Door
Fig. 5B
1. Route ET harness through wire run channel for wood doors (Fig. 5A)
and through access hole for metal doors (not shown).
2. Mount exit chassis carefully. Do not pinch harness wires.
3. Position exit chassis on door with lever arm under
rear section of mortise lock.
4. Secure chassis and ET with (2) 1/4-20 x
2-3/8" flat head machine screws.
(4) #10 Wood or
#10-24 Machine
Screws
6 Install Cylinder
For devices without cylinders, skip this section.
1. Verify orientation of cylinder (Fig. 6A).
2. Slide cylinder through ET trim and thread into the lock body,
rotating the cylinder clockwise.
Cylinder should rest flush on ET case.
3. Tighten the cylinder clamp screw using
#2 Phillips screwdriver to prevent the
cylinder from unscrewing (Fig. 6B).
4. Test cylinder function:
For 77 Function, ensure that the key retracts latch.
Outside of Door
Fig. 6B
Cylinder
Clamp
Screw
Fig. 6A
Correct
Incorrect
