Pigtail harness
assembly with
8-pin connector
4
1
2
57- 80 Series Rail
with 8-pin connector
3
Electric Hinge with
8-pin hinge connector
Raceway harness with
8 & 4-pin connectors.
The 4-pin connectors are not
used here.
Note:
No field rail cutoff allowed. Exit device must be ordered for specific door width.
Mount exit device per instruction sheet provided.
To insure trouble free operation, check that the push rail can be fully depressed. On vertical rod exit devices,
check that the latch bolts do not go into hold back position until the push rail is fully depressed.
Plug rail connector into raceway connector then feed through 1” hole in door. Install rail mounting bracket with two
screws supplied. Install rail end cap.
Plug raceway connector into electric hinge connector then feed through door prep. Mount electric hinge to door.
Go to (
A
) if wiring now. Go to (
B
) if wiring is to be done later.
A. Refer to sections 8 and 9. Wire loose frame side wires to loose wires on pigtail harness as
required using connectors allowed by local code. Plug pigtail harness connector into electric hinge connector.
Feed harnesses through frame prep and mount electric hinge. Refer to operating instructions in section 10. Apply
power and test exit device.
B. Plug pigtail harness connector into electric hinge connector. Feed harnesses through frame prep and mount
electric hinge.
Mounting
bracket
1” dia. hole
in door
Screw
locations
Ring terminal
(from harness)
1
2
3
4
Exit Device Plug-in Connector Installation
8
Insert bracket mounting screw through *ground
ring terminal. Fasten mounting bracket with
mounting bracket screws (ring terminal).
*Ring terminal must be grounded as indicated.
!
14 1-800-810-WIRE • www.sargentlock.com • A7743E
Copyright © 2016, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
02/29/16
Delayed Egress 57- 80 Series Exit Device