1-800-727-5477 • www.sargentlock.com
A7668B 3/20
Copyright © 2009, 2019, 2020 SARGENT Manufacturing Company. All rights reserved. Reproduction
in whole or in part without the express written permission of SARGENT Manufacturing Company is
prohibited.
3
Lever Installation
3
1 . IMPORTANT: Before installing levers read, “SPECIFIC INSTRUCTIONS PER FUNCTION -
BEFORE INSTALLING LEVER” on page 4 of T-Zone Installation Instructions A7469 .
2. Place cylinder in outside lever. Insert key and rotate 45 degrees clockwise.
3. With key rotated, push lever onto sleeve until hole on inside of lever is over Security Attachment
Screw. If screw interferes with assembly, check that screw is fully threaded into black lever catch.
4. Using screwdriver provided, rotate Security Attachment Screw
counter-clockwise
until flush with the
surface of the lever.
5. Secure lever with 6 lobe security screws. Screws should be flush when properly tightened.
6. Rotate key to horizontal and remove.
7. Assemble inside lever and secure with 6 lobe TORX® security screws.
Cylinder Removal
4
1. Remove the security screw on the outside of the lever with TORX® wrench.
2. Insert key and
rotate key 45º clockwise . Keep key in this position
.
3. Using screwdriver, tighten the Security Attachment Screw
clockwise
until it clears the lever.
4. Remove lever and remove key.
5. Remove cylinder from lever and install new cylinder.
6. Reinstall lever, following step 3 above.
11 Line w/ SL- Option
Installation Instructions
Bored Lock
