ISW91DCP 05/20
Copyright © 2016, 2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
4
Model W91DCP,
Wood Frame
E. Assemble track.
1. Slide track components into track.
(Figure 6)
NOTE:
• All track components must be placed in
track before installing track into door.
• Stop block (or optional hold open)
should be last component at hinge side
of track.
• The longer end of slider should be
pointed towards hinge end of track.
Figure 6
F. Install track to door.
1. Make sure slider and track components are
installed prior to installing track to door.
2. Install track and, if necessary, optional
spacer (replacement application only,
consult factory) using four (4) #14 x 1-5/8"
FHPWS screws provided. (Figure 7)
G. Attach arm to track.
Non Hold Open Track Components
Optional Hold Open Track Components
Figure 7
Figure 8
Figure 9
1. With provided 1/8" hex wrench, completely
tighten latch and sweep valves by turning
screws clockwise. This will allow for an easier
closer-to-door connection. (Figure 8)
2.
Open door to about 45° then rotate arm over
to door.
NOTE: Arm should maintain position because
latch and sweep valves have been tightened.
3. Align slider square with arm square and
connect using provided 5/32" hex wrench and
1/4-20 x 3/4" Allen Drive with Patch screw and
washer. (Figure 9)
NOTE: If you choose to open door beyond
45°, backcheck may need to be adjusted
counter clockwise to easily rotate arm to
door position.
