Interior
Exterior
In
Swing
Exterior
Out
Swing
Size of Door
Equivalent
Closer Size
(Approx.)
2 4 (712)
' "
2 6 (764)
' "
3 0 (915)
' "
3 6 (1067)
' "
3
4
5
6
2 6 (764)
' "
3 0 (915)
' "
2 6 (764)
' "
3 0 (915)
' "
3 6 (1067)
' "
4 0 (1219)
' "
2-7
7-11
11-15
15-17
Spring Power
Adjustment
No. Full Turns
Clockwise
LATCHING
SPEED VALVE
BACKCHECK
INTENSITY VALVE
CLOSING
SPEED VALVE
SPRING POWER ADJUSTER
(1/4 ALLEN WRENCH)
"
SPRING POWER ADJUSTMENT CHART
Spring Power Adjustment
Size 1 thru 6 Adjustment See Chart
All 9500 closers are factory set at an approximate
Size 3.
Adjust closer as necessary for door size using this chart.
Readjustment may be required to suit prevailing conditions.
Locate spring power adjuster from
Illustration below
Backcheck Intensity Valve
Factory preset for typical doors.
Turn valve COUNTER-CLOCKWISE to reduce backcheck
or CLOCKWISE to increase backcheck. (Backcheck should
be set to give a soft cushioning action, not a sudden stop.)
Latching Speed Valve
Factory preset for typical doors.
After closing speed has been obtained, turn latching speed valve
CLOCKWISE to SLOW latching or COUNTER-CLOCKWISE to
SPEED latching for last 2 to 5 of door travel.
"
"
NOTE: Set combination of CLOSING and LATCHING speeds to
between 3 and 7 seconds Use of door by handicapped,
elderly or small children may require even greater
closing time.
Closing Speed Valve
Factory preset for typical doors.
To adjust speed of door closing from fully open to a position
2 to 5 from closed, turn Closing Speed Valve CLOCKWISE
"
"
to SLOW closing, COUNTER-CLOCKWISE to SPEED
closing.
Delayed Action Valve
Factory preset for typical doors.
Turn valve CLOCKWISE to SLOW closing, COUNTER-
CLOCKWISE to SPEED closing. Delayed action may be
adjusted from 20 seconds to 90 seconds, depending on
degree of door swing. Delay occurs at the beginning of the
door closing cycle from fully open down to 70°, where the
closing speed valve then begins its control.
h
e
k
c
c
c
k
a
B
h
ct
a
L
d
e
e
p
S
g
ni
s
o
l
C
ye
la
d
e
D
t
io
c
n
A
Option
(1/8 Allen Wrench Provided)
(1/8 Allen Wrench Provided)
(1/8 Allen Wrench Provided)
Date Stamp
(on end of closer)
MM-YY
OPTIONAL
DELAYED
ACTION VALVE
MM = Month
YY = Year
Unit Adjustment
Page 7
80-9395-9513-020 REV. 2 (01-18)
Norton® is a registered trademark of Yale Security Inc., an ASSA ABLOY Group company.
Copyright © 2013, 2018 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
ASSA ABLOY
Approved 2018-01-19
