Copyright © 2019, ASSA ABLOY Accessories and Door Controls Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
2
80-9377-3204-020
Rev 1 05/19
Before You Begin
• For special applications, a separate door and frame preparation
template is packed with these instructions. Use these instructions
for installation sequence and closer adjustments only.
• 7500 Series closing force is adjustable from 1-6 as outlined in
ANSI Standard A156.4. When closer is adjusted to conform to
ADA reduced opening force requirements (5 lbs max.) for interior
doors, it may not have adequate closing force to reliably close
and latch door. Charted power adjustments in instructions are
recommended where possible, to ensure proper door control.
Mounting Hardware
Door or Frame
Drill
Closer, H/O Shoe or Optional PA Bracket:
1/4-14 x 1-1/2 Oval Flat Head Mach. Screw
Wood
3/16" (4.76mm)
Closer, H/O Shoe or Optional PA Bracket:
1/4-20 x 3/4 Oval Flat Head Mach. Screw
Metal
Drill #7 (.201 dia. or 5.10mm)
Tap 1/4-20
H/O Shoe to Optional PA Bracket:
1/4-20 x 1/2 Oval Flat Head Mach. Screw
Closer:
Sleeve Nut and Bolt (SNB)
(optional)
Hollow Metal
9/32" (7.00mm) thru
3/8" (9.50mm) door face opposite to closer
Aluminum or Wood 3/8" (9.50mm) thru
Closer:
Thru Bolt and Grommet Nut (TBGN)
(optional)
All
9/32" (7.00mm) thru
3/8" (9.50mm) dia. x 3/8" (9.500mm) deep,
door face opposite to closer
• Doors should be hung on ball bearing or anti-friction hinges.
• A separate door stop is recommended.
• Always consult door/frame manufacturer for fastener
compatibility.
• Door and frame must be properly reinforced.
• Adjust closing time speed between 3 and 7 seconds from
90° to 0°.
• These door closers should NOT be installed on exposed side
(weather side) of exterior doors.
• Dimensions are given in inches (millimeters).
Closer Adjustments
Latch
Backcheck
Do not over tighten screws.
Cover
Regular Arm
Top Jamb Mount
Parallel Arm
ATTENTION:
An incorrectly installed or improperly adjusted door closer can
cause property damage or personal injury. These installation
instructions should be followed to avoid the possibility of
misapplication or misadjustment.
Spring Closing
Power
Backcheck
Position
Sweep or
Delayed Action
Sweep on
DA Closer
Normally
Closed. Open
to delay in door
opening cycle.
Use provided hex wrench to turn valves.
NEVER force valves out of closer.
NEVER completely close backcheck valve.
Door must be open to adjust spring
closing power. Refer to specific charts on
installation pages.
Do not use a power
drill. Warranty will be void.
