6
To install batteries, first remove Battery Pack Cover by depressing the buttons
on the top and bottom of the case, then gently remove cover.
Insert 4 good quality alkaline AA batteries into the Battery pack as shown.
2 in the upper battery compartment and two in the lower battery compartment.
Batteries must be new good quality alkaline and not be mixed between new and old.
Caution: Dispose of them responsibly and do not throw batteries in fire.
Product Definitions
EZ Mode:
(Factory default) In this mode you are able to enrol one User PIN code as well as
20 additional key cards.
This mode is normally used for a residential homes.
Advanced Mode:
This mode can be selected at point of installation.
Advanced mode
enables you to have a master
code, the master code is able to add 20 different users with a PIN code and 20 Users with a
Key Card (40 users in
total). Only the master can add or delete users using their PIN. This is normally used to
control access or where
users may be removed when required.
User PIN Code:
Is a personalised identification number that consist of 4-12 digits
Master Code:
Is a personalised identification number that consist of 6 digits and is only
required when in
advanced mode. The Master code has the ability to add and delete users.
Key Card:
Is a unique card that can be used like a key. The Key Card can be reused as
many times as you want.
The Key Card can be used as a backup if you forget your pin code or used instead of your
pin. To use the Key Card
present it near the centre of the Touch screen for 1-2 seconds, the Key Card does not have
to touch the keypad and
can be 2cm away from the lock.
Confirm button:
The button is used to complete verification after user PIN code is entered.
Wrong Code/card Entry Limit:
After 5 unsuccessful attempts at entering a valid user PIN
code or Valid Key Card the
unit will shut down for 3 minutes and not allow operation during this time. The lock will
display how many minutes
are left in this lock down mode, as per page 6.
Registration Button:
Located on the battery pack mounting Plate, the Registration button is
used for changing the
user PIN code or enrolling new Key Cards (Only in EZ mode).
Low Battery:
When the battery power is low, the low battery icon will appear. Further more
the lock will beep
5 times when unlocked. If battery power is completely lost, the emergency power supply can
be used.
Low Battery check:
The battery level can be checked without removing the batteries. With
a simple sequence of
buttons you can check your battery level (Between 100%-30%). Refer to page 10 For more
details.
Emergency Power Supply:
9V battery connections are located under the front of the
outside escutcheon. In the
event that the four AA alkaline batteries are completely discharged, a 9V battery can be
used to supply power to the
lock. While connecting the 9V battery, the lock can be operated as normal, thus granting
access so the four AA
alkaline batteries can be replaced.
Soft reset:
Located in between the Emergency 9V Power socket this small hidden button is
used to refresh the
