ASSA ABLOY, the global leader in door opening solutions
3
Step 1 – Installation of the Deadbolt Assembly
·
Place the window shutter on a horizontal surface
with the pin lever notch located at the top of the
shutter facing up.
·
The recommended deadbolt assembly location
should be equidistant from the top and bottom of
the shutter.
·
Assemble the deadbolt case into the lock pocket
provided in the door. Note the orientation of the
lock, the top of the deadbolt case indicates that
this should be toward the top of the shutter.
·
Assemble the lock to the edge of the shutter
using (2) 1/4 – 20 by 1" Flat Head Cap Screws.
Step 2 – Installation of the
Bottom Bolt Assembly
·
Loosen the set screw so that the lifting platform will slide along
the lower rod tubing but not slide on its own when the rod is
held vertically. Be sure that the set screw is oriented so that it
will be accessible through the Lower Thru Bolt Cutout on the
top side of the shutter.
·
When you insert the assembly into the shutter and through the
nylon guides of the deadbolt case this lifting pad will be in a
position to allow you to make the final necessary adjustment.
Note the orientation of the bottom bolt assembly the double
screw head side (not shown in this image) should be facing the
hinge side of the shutter.
Continue on next page………….
Set Screw
Lower Thru
Bolt Cutout
