STEP 4 HANDING THE eForce
®
Prox & iCLASS
•
The eForce
®
is shipped in
a non-handed neutral
position with the access
cover off as shown.
•
To hand the eForce
®
,
rotate the handle into the
desired position until two
detent clicks are
completed.
•
Proceed to step 5 if
installing the 3090P-02
& 3090C-02
The output hub, located on the back of the eForce
®
, is shipped with a
clockwise rotation as viewed from rear. In some instances, this rotation must
be changed to match the device and/or hand of the door (refer to Handing
Setup Chart). To change rotation, insert a flat screwdriver into the output hub
(Fig. 11) located on the back of the eForce
®
and turn approximately 270°
Clockwise or Counter-Clockwise. This will reconfigure the unit to the opposite
rotation.
HANDING SETUP CHART
D
EVICE
T
YPE
L
EFT
H
AND
R
EVERSE
R
OTATION
R
IGHT
H
AND
R
EVERSE
R
OTATION
SVR CLOCKWISE
CLOCKWISE
Mortise Latch
COUNTER-CLOCKWISE
CLOCKWISE
CVR CLOCKWISE
CLOCKWISE
Rim COUNTER-CLOCKWISE
COUNTER-CLOCKWISE
Fig. 11
10
80
‐
0180
‐
327
Rev.
A
