ASROCK N7AD-SLI, Installation Manual

Page: 16 / 166

1 6 1 6
1 6 1 6 1 6
ASRock N7AD-SLI Motherboard
EnglishEnglishEnglishEnglishEnglish
1. If you plan to install only one PCI Express VGA card on this
motherboard, please install it on PCIE2 slot (Green). In this mode,
you do not need to adjust the default setting of ASRock SLI/XFire
Switch Card, and please do not remove or lose ASRock SLI/XFire
Switch Card when it is still in working condition.
2. For the information of the compatible SLI TM Mode PCI Express VGA
cards and SLI TM setup procedures, please refer to the “Supported
PCI Express VGA Card List for SLI
TM
Mode” on page 9 and “SLI
TM
Operation Guide” on page 17.
Installing an expansion card Installing an expansion card Installing an expansion card Installing an expansion card Installing an expansion card
Step 1. Before installing the expansion card, please make sure that the power
supply is switched off or the power cord is unplugged. Please read the
documentation of the expansion card and make necessary hardware
settings for the card before you start the installation.
Step 2. Remove the system unit cover (if your motherboard is already installed in a
chassis).
Step 3. Remove the bracket facing the slot that you intend to use. Keep the screws
for later use.
Step 4. Align the card connector with the slot and press firmly until the card is
completely seated on the slot.
Step 5. Fasten the card to the chassis with screws.
Step 6. Replace the system cover.