ASROCK M3A790GXH/128M, Installation Manual

Page: 32 / 218

3 2 3 2
3 2 3 2 3 2
ASRock M3A790GXH/128M Motherboard
EnglishEnglishEnglishEnglishEnglish
2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2 No. 31)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 12)
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors These six Serial ATAII (SATAII)
(SATAII_1: see p.2, No. 17)
connectors support SATAII
(SATAII_2: see p.2, No. 18)
or SATA hard disk for internal
(SATAII_3: see p.2, No. 20)
storage devices. The current
(SATAII_4: see p.2, No. 19)
SATAII interface allows up to 3.0
(SATAII_5: see p.2, No. 22)
Gb/s data transfer rate.
(SATAII_6: see p.2, No. 23)
connect the black end
to the IDE devices
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
SATAII_6 connector can be used for internal storage device or be
connected to eSATAII connector to support eSATAII device. Please
read “eSATAII Interface Introduction” on page 37 for details about
eSATAII and eSATAII installation procedures.
eSATAII Connector This eSATAII connector
(eSATAII_TOP: see p.2, No. 42)
supports SATA data cable for
external SATAII function. The
current eSATAII interface
allows up to 3.0 Gb/s data
transfer rate.
SATAII_6 SATAII_5
SATAII_1 SATAII_2
SATAII_3 SATAII_4
eSATAII_TOP
the red-striped side to
Pin1